Dynacord DSA 8805 User Manual download pdf (Page 16)

DIGITAL SYSTEM AMPLIFIER

16 Owner‘s Manual

Controls and Connections

1 INIT button

The INIT button allows resetting the RCM-810 to factory settings. Press the button for at least 3 seconds

using e.g. a small screwdriver. Table 4.1 lists the factory settings of the RCM-810 module.

2 CAN ADDRESS Selector Switch

The two address selector switches are for setting the network address of the RCM-810. CAN networks

support addresses in the range of 01 to 250 (FA hex). Addressing has to be carried out in the hexadecimal

number system. The LOW selector switch sets the lower digit, while HIGH sets the higher digit.

Address 0 (00 hex, delivery status) disables remote communication between the RCM-810 and the bus. The module does not

appear in the system, even though it is physically connected to the CAN-bus.

Illustration 4.1: Controls and Connections of the RCM-810

CAUTION:

All RCM-810 parameters configured via IRIS-Net are discarded when pressing the INIT

button.

Parameter Value

CAN-Bus data rate 10 kbit/s

Power-On-Delay 0 ms

Amplifier & Channel Labels RCM-810 Module, RCM-810 Input, RCM-810 Output

Supervision not configured

Control Ports and Job Numbers not configured

VLD deactivated

Table 4.1: Factory Settings of RCM-810

CAUTION:

Each address may exist only once in a system. Otherwise, network conflicts may arise.

HIGH LOW Address HIGH LOW Address

0 0 Stand-alone 8 0...F 128...143

0 1...F 1...15 9 0...F 144...159

1 0...F 16...31 A 0...F 160...175

2 0...F 32...47 B 0...F 176...191

3 0...F 48...63 C 0...F 192...207

4 0...F 64...79 D 0...F 208...223

5 0...F 80...95 E 0...F 224...239

6 0...F 96...111 F 0...A 240...250

7 0...F 112...127 F B...F reserved

Table 4.2: CAN addresses

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

No comments

Dynacord DSA 8805 User Manual Page 16