DYNACORD CMS 600-3 Owner's Manual download pdf (Page 15)

CMS

2.4 AUX

Generally, the AUX channel is used for the connection of an additional, external FX unit. Depending on the setting of the

AUX 1/2 POST button, it is also possible to configure the bus for monitoring purposes. Additionally the AUX channel is

available at the DIGITAL AUDIO INTERFACE (channel USB 3).

30 - AUX SEND

This output provides connection for an external FX unit or, when used for monitoring, a power amplifier or active stage

monitor speaker systems. Using the AUX fader allows setting the output level in a wide range up to +20 dBu. The AUX

SEND is designed in Ground Sensing technology to prevent the induction of external noise, even with long cables. Use

balanced cables for the connection of external components whenever it is possible.

31 - AUX PRE/POST/

TO FX 2

The current mode of the AUX channel is indicated by this LEDs. Please refer to page page 23 for more details about the

available modes.

32 - MUTE

The MUTE button mutes the AUX output signal.

33 - AUX

FADER

This fader controls the summed audio signal at the AUX output. When used for monitoring, this fader lets you control

the volume of the monitor system. When using the DIGITAL AUDIO INTERFACE for recording this fader also controls the

volume of the sent channel USB 3. See page 26 for details about using the DIGITAL AUDIO INTERFACE.

2.5 MON

34 - MONITOR

This output provides connection for an power amplifier or active stage monitor speaker systems. The MONITOR output

is designed in Ground Sensing technology to prevent the induction of external noise, even with long cables. Use bal-

anced cables for the connection of external components whenever it is possible. Additionally the MON channel is avail-

able at the DIGITAL AUDIO INTERFACE (channel USB 4).

35 - MUTE

The MUTE button mutes the MON output signal.

36 - MON

FADER

This fader controls the summed audio signal at the MONITOR output. When using the DIGITAL AUDIO INTERFACE as

output, this fader also controls the volume of sent channels USB 4.

2.6 MASTER with GEQ

37 - USB 2.0 DIGITAL AUDIO INTERFACE

The USB interface of the CMS is a USB B (female) connector. Please refer to chapter “DIGITAL AUDIO INTERFACE” on

page 26 for more details.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 79 80

No comments

DYNACORD CMS 600-3 Owner's Manual Page 15